The products of the Strip LINE MONO series allow architects and craftsmen to give life to lighting projects in indoor and outdoor environments, guaranteeing an elegant and minimal effect and enhancing architectural elements or furnishings in an original and creative way with light. The Strip LINE MONO model is presented as a horizontally flexible product with a minimum bending diameter of 50mm, completely made of polyurethane resin. Extremely uniform brightness, without pitting, from the top. Strip LINE does not yellow, is not subject to premature aging and overheating typical of classic LED strips. It can be installed on the ceiling using the clips supplied or recessed in furnishings or boiserie, by gluing.
Source
LED module with copper double-sided Kapton® PCB and gold-plated printed circuits, specially designed to ensure maximum uniformity and the total absence of point light.
Optics
Roto-symmetrical emission protected by a layer of opal resin designed to reduce glare. The device is suitable for installation in UGR <19 (EN12464-1) work environments.
Power supply
Electronic ballast not supplied. 24Vdc power supply.
Note
The product can be cut at intervals of 100mm (see datasheet), the maximum length that can be fed is 5000mm. The accessories and connectors are IP20 and make the strip IP20 in the case of cuts and joints.
Accessories
Electronic power supply, available in the standard (on-off), dimmable version.
Steel clip for ceiling mounting.
Wired and non-wired closing caps, useful for feeding and closing fractional parts of the product.
FAQ
If I don't use all of the intended coil, can I reuse it in another environment?
The LED Strips can be cut along the dotted line on the product and the caps are supplied and, upon request, any restarts for other environments and the related power supplies.
Does the product require a power supply?
Yes, the lighting body requires a connection to the power supply, all protected from water ingress. The connection must have an IP rating greater than or equal to that indicated on the product. The power supply can be remote, evaluating its position with respect to the product together with us.
Can I connect multiple products to a single power supply?
During the estimate phase, the connection of one or more lighting fixtures to the power supply will be evaluated based on the arrangement in the room and the distance of the products from the driver. There are electronic power characteristics that must be evaluated by our technical office. Please request any information from your reference contact.
How long can I get the product formwork to be able to install it on site?
The formwork is ready for delivery at the time of order.
Does the product require formwork?
Yes, for the correct installation of the product, we provide the formwork to be positioned during the construction phase. Where it is not possible to install the formwork, an alternative can be studied for the correct installation of the product.
Do you provide connectors for this product?
Yes, the product is supplied with the appropriate connectors it needs.