LED projector for wall and ceiling installation using special brackets, suitable for illuminating elevations and facades, creating lighting effects of great value, useful for enhancing architecture. Frame in AISI 316L steel with polished finish, fixed to the lamp body by means of stainless steel clamping screws. Body in extruded anticorodal aluminum. The projector can be adjusted in the vertical plane ± 90 ° by means of a steel bracket equipped with mechanical blocks which guarantee stable aiming of the light beam. The horizontal aiming takes place through the holes and slots the bracket is supplied with. Optical compartment closed at the top by an extra-clear glass screen (15mm thick) tempered and fixed by resin; it is coplanar with the body of the appliance to allow water and dirt to flow out, avoiding the formation of deposits that would significantly reduce the performance of the appliance.
Source
LED Chip On Board (COB) technology.
Optics
Roto-symmetrical optics available in various openings (see table opposite) treated by high vacuum metallization and protected by a tempered extra-clear safety glass screen.
Power supply
Electronic power supply (supplied as an accessory), available in the standard (on-off) and dimmable (DALI) version. Electronic ballast not supplied. Power supply 24Vdc
Note
Outgoing power cable with length L = 1000mm in 2×0.75mm² neoprene. IP65 protection both on the product and on the cable using IP65 connectors. The product is not suitable for installation in swimming pools and fountains. We recommend the use of the SPD protection device, supplied by us upon request.
Accessories
Electronic ballasts available in standard (on-off) and dimmable (DALI) versions, for single or multiple installations. Formwork for masonry installation.
FAQ
Does the product require a power supply?
Yes, the lighting body requires a connection to the power supply, all protected from water ingress. The connection must have an IP rating greater than or equal to that indicated on the product. The power supply can be remote, evaluating its position with respect to the product together with us.
Can I connect multiple products to a single power supply?
During the estimate phase, the connection of one or more lighting fixtures to the power supply will be evaluated based on the arrangement in the room and the distance of the products from the driver. There are electronic power characteristics that must be evaluated by our technical office. Please request any information from your reference contact.
Does the product have set cable lengths?
The lighting body is supplied with standard cable lengths, but, for some products, different cable sizes may be required.
Can it be placed outside?
The product can be installed outdoors, but it is necessary that the product and the connection system have an adequate IP protection rating.