LED luminaire for recessed lighting, which can be installed on the floor using the formwork (supplied as an accessory), suitable for illuminating elevations and facades, creating lighting effects of great value, useful for enhancing architecture and green areas. Frame in AISI 316L steel with satin finish, fixed to the lamp body by means of stainless steel clamping screws. Body in extruded anticorodal aluminum. The fixture is fixed to the formwork, made of galvanized aluminum sheet, by tightening the stainless steel screws. Optical compartment closed at the top by a tempered extra-clear glass screen (15mm thick) fixed by resin and coplanar to the luminaire body to allow water and dirt to flow, avoiding deposits that would significantly reduce the performance of the luminaire.
Source
LED Chip On Board (COB) technology.
Optics
Roto-symmetrical optics available in various openings (see table opposite) treated by high vacuum metallization and protected by a tempered extra-clear safety glass screen.
Power supply
Electronic power supply (supplied as an accessory), available in the standard (on-off) and dimmable (DALI) version. Electronic ballast not supplied. Power supply 24Vdc.
Note
Outgoing power cable with length L = 1000mm in 2×0.75mm² neoprene. IP65 protection both on the product and on the cable using IP65 connectors. The product is not suitable for installation in swimming pools and fountains. We recommend the use of the SPD protection device, supplied by us upon request.
FAQ
How long can I get the product formwork to be able to install it on site?
The formwork is ready for delivery at the time of order.
Does the product require formwork?
Yes, for the correct installation of the product, we provide the formwork to be positioned during the construction phase.
Does the product require a power supply?
Yes, the lighting body requires a connection to the power supply, all protected from water ingress. The connection must have an IP rating greater than or equal to that indicated on the product. The power supply can be remote, evaluating its position with respect to the product together with us.
Can I connect multiple products to a single power supply?
During the estimate phase, the connection of one or more lighting fixtures to the power supply will be evaluated based on the arrangement in the room and the distance of the products from the driver. There are electronic power characteristics that must be evaluated by our technical office. Please request any information from your reference contact.
Does the product have set cable lengths?
The lighting body is supplied with standard cable lengths, but, for some products, different cable sizes may be required.
Can it be placed outside?
The product can be installed outdoors, but it is necessary that the product and the connection system have an adequate IP protection rating.