LED projector for wall, floor and pole systems installation, suitable for lighting outdoor commercial areas, parks and green areas, consisting of lamp body and glass-holder frame made of anodized aluminum alloy and subsequently powder-coated to provide a high resistance to atmospheric agents and UV rays. The projector can be adjusted in the vertical plane ± 90 ° by means of a painted steel bracket equipped with mechanical locks that guarantee stable aiming of the light beam. The horizontal aiming takes place through the holes and slots the bracket is supplied with. Protective glass (4mm thick) plus gasket fixed to the frame by silicone, to avoid the formation of deposits that would significantly reduce the performance of the appliance. Stainless steel screws with a high molybdenum content. Annealed silicone sealing gaskets. Equipment equipped with decompression valve. IP67 protection both on the product and on the cable using IP67 connectors.
Source
LED Chip On Board (COB) technology.
Optics
Roto-symmetrical optics available in various openings (see table opposite) treated by high vacuum metallization and protected by a tempered extra-clear safety glass screen fixed by silicone.
Power supply
Electronic power supply integrated in the body of the fixture, available in the standard version (on-off). Power supply 220-240Vac 50 / 60Hz.
Accessories
Aluminum flange for installation on poles ø 90mm – for 1 DALLAS floodlight or for 2 DALLAS floodlights.
Note
Available in both single and double emission versions. We recommend the use of the SPD protection device, supplied by us upon request.
FAQ
Can I request a particular color for this product?
During the estimate phase, the request will be evaluated following the RAL colors indicated by you.
The provision of a specific color also depends on the environment in which the lighting fixture will be positioned.
Can it be placed outside?
The product can be installed outdoors, but it is necessary that the product and the connection system have an adequate IP protection rating.