LED floodlight for ground installation with spike (supplied as an accessory), suitable for lighting outdoor green areas, gardens or pedestrian walkways. Main body in billet aluminum, anodized and subsequently powder coated to provide high resistance to atmospheric agents and UV rays, acts as a radiant surface and guarantees optimal heat dissipation. The special joint present in all versions of CANNON guarantees complete freedom in directing the light beam, the aiming is blocked by tightening the stainless steel stops. Tempered extra-clear front protective glass (5mm thick) fixed by resin in a coplanar position with the body of the appliance to allow water and dirt to drain, avoiding the formation of deposits that would significantly reduce the performance of the appliance. Stainless steel screws with a high molybdenum content. Annealed silicone sealing gaskets.
Source
LED Chip On Board (COB) technology 6W @ 350mA 18V.
Optics
Roto-symmetrical optics available in various openings (see table opposite) treated by high vacuum metallization and protected by a tempered extra-clear safety glass screen fixed by resin.
Power supply
Electronic ballast (supplied as an accessory), available in the standard version (on-off). Power supply 220-240Vac 50 / 60Hz.
Note
Outgoing power cable with length L = 400mm in 2×0.75mm² neoprene. IP67 protection both on the product and on the cable using IP67 connectors. The product is not suitable for installation in swimming pools and fountains. Also available in the stem, stem, maxi and line version (see catalog).
We recommend the use of the SPD protection device, supplied by us upon request.
Accessories
Electronic ballasts available in standard (on-off) and dimmable (DALI) versions, for single or multiple installations. Spike for ground installation.
FAQ
Does the product require a power supply?
Yes, the lighting body requires a connection to the power supply, all protected from water ingress. The connection must have an IP rating greater than or equal to that indicated on the product. The power supply can be remote, evaluating its position with respect to the product together with us.
Can I connect multiple products to a single power supply?
During the estimate phase, the connection of one or more lighting fixtures to the power supply will be evaluated based on the arrangement in the room and the distance of the products from the driver. There are electronic power characteristics that must be evaluated by our technical office. Please request any information from your reference contact.
Does the product have set cable lengths?
The lighting body is supplied with standard cable lengths, but, for some products, different cable sizes may be required.
Can I request a particular color for this product?
During the estimate phase, the request will be evaluated following the RAL colors indicated by you.
The provision of a specific color also depends on the environment in which the lighting fixture will be positioned.
Can it be placed outside?
The product can be installed outdoors, but it is necessary that the product and the connection system have an adequate IP protection rating.
