LED luminaire for recessed lighting, which can be installed on the floor using the formwork (supplied as an accessory), suitable for enhancing pedestrian paths, green areas and outdoor areas of particular architectural value. Main body in billet aluminum, anodized and subsequently powder coated to provide high resistance to atmospheric agents and UV rays, acts as a radiant surface and guarantees optimal heat dissipation. Tempered glass diffuser with satin “frost” effect designed to reduce glare (15mm thick) inserted by pressure into the lamp body and held in position by resin; the coplanar position with the body of the appliance to allow water and dirt to flow out, avoiding the formation of deposits that would significantly reduce the performance of the appliance.
Source
DOB LED module specially designed to ensure maximum uniformity.
Optics
Roto-symmetrical optic (see table on the side) protected by a glass screen with a “frost” satin effect designed to reduce glare.
Power supply
Electronic ballast not supplied. 12Vdc power supply.
Note
The product is supplied with a single cable gland and outgoing power supply cable L = 800mm in 2×0.75mm² neoprene. The correctly installed device guarantees resistance to a static load of 2000kg. IP67 protection both on the product and on the cable using IP67 connectors. We recommend the use of the SPD protection device, supplied by us upon request.
Accessories
Electronic ballasts available in the standard version (on-off), for single or multiple installations. Formwork for installation.
FAQ
How long can I get the product formwork to be able to install it on site?
The formwork is ready for delivery at the time of order.
Does the product require formwork?
Yes, for the correct installation of the product, we provide the formwork to be positioned during the construction phase.
Does the product require a power supply?
Yes, the lighting body requires a connection to the power supply, all protected from water ingress. The connection must have an IP rating greater than or equal to that indicated on the product. The power supply can be remote, evaluating its position with respect to the product together with us.
Can I connect multiple products to a single power supply?
During the estimate phase, the connection of one or more lighting fixtures to the power supply will be evaluated based on the arrangement in the room and the distance of the products from the driver. There are electronic power characteristics that must be evaluated by our technical office. Please request any information from your reference contact.
Does the product have set cable lengths?
The lighting body is supplied with standard cable lengths, but, for some products, different cable sizes may be required.
Can it be placed outside?
The product can be installed outdoors, but it is necessary that the product and the connection system have an adequate IP protection rating.